Operator - TS75

The TS75 can be used for heavier single garage doors (eg. with a steel frame and timber surface) and a double garage door.

* Installation instructions for the TS75 operator

* User guide for the TS75 operator

* Please click here for trouble shooting

Do you have a technical question? If you require any further technical information, you can email us directly

Low Power Consumption

Save energy by using a Seip door operator. Power consumption is only 2.3 watts in stand-by mode.

Completely Maintenance Free

All models are equipped with an automatic chain tensioning system, keeping the chain tensioned continuously. The C-rail profile protects the chain from dust - no expensive maintenance calls.

Quality

The C-rails and base-plates of our operators are made of 2mm galvanized steel. With the chain drive system we also provide approved quality - chains have been offering excellent reliability for decades.

Soft-Start and Soft-Stop as standard

A feature originally introduced by Seip: by speeding up slowly and reducing the speed before every stop, noises caused by the garage door are reduced to a minimum or even eliminated.

Automatic Force Measurement

This means that the required force for operating your door is precisely measured by the operator. Should it meet with an obstruction, it will automatically reverse direction. No fuss - no problem.

Automatic Light

On each operation the internal automatic light becomes active. The 230v light can be adjusted to stay on between 80 to 240 seconds.

 

Equipment supplied as standard with all Seip operators
Wall Push Button
This is an additional means of opening and closing the garage door no wiring required. Hard-wired rocker style wall switch.
Emergency Release

The standard emergency release can be connected to the garage door handle. In case of a power cut, your door can be manually operated from the outside using the existing door handle while still maintaining a high degree of security.

For doors without a handle, we supply (as standard) a small handle that is connected directly to the quick release cable.

2 x 4 Channel Hand Transmitter
With one transmitter you may control a maximum of 4 items, one of which is your garage door operator. External receivers (optional) will allow you to use the remaining three channels individually, eg. for entrance lights, a gate operator or your alarm system.
433 MHz Remote Control
This is a high performance frequency which provides a good range, and trouble free operation in most situations and areas.
The "Rolling Code" Coding System
Our rolling code radio system ensures complete peace of mind. with millions of different codes, it is virtually impossible to clone.

 

 

 

All our operators are independently tested to comply with the stringent European Directives (CE standards)
* Up-and-Over Doors (Tilting Door)
* Sectional Doors

* Side Hinged Doors

(Optional extra required: conversion kit for side hinged doors)